Bricasti M28 Monoblock Amplifier

The Bricasti M28 monoblock amplifier is an exceptionally pure and precisely controlled reservoir of current. The expression of craft wrought in this deep pool effortlessly provides the massive current required to grab onto and control any speaker through the most demanding of musical passages. The sought after listening experience that is so elusive is immediately evident. Ruler flat response and vanishing distortion of course. Fast, articulate, distortion free low frequency performance, even at the speakers resonant peak, perhaps unanticipated.

A balanced differential structure minimizes the stress across each of the M28 amplifier's internal elements. Pairing the M28 with the balanced structure of the Bricasti M1 digital to analog converter forms a balanced differential signal flow from source to speaker.

200w/ 400w /800w balanced power amplifier with Stillpoints embedded in the feet.

See the Bricasti M28 review from parttimeaudiophile here.

Made in the USA.

Total Harmonic Distortion THD+N less than 0.005% 20hz-20kHz at full rated power into 8, 4 and 2 ohms.
Power 200W into 8 ohms, 400W into 4 ohms, 800W into 2 ohms.
Frequency response 10hz-150kHz, within 0.5db.
Signal to Noise greater than 95db at full rated.
Power Topology Fully Differential, bi polar.
Balanced Input XLR connector 200k ohm impedance.
Unbalanced Input RCA connector 100k ohm impedance.
Weight 85 lbs.
Shipping Weight 100 lbs.
Finish Anodized Aluminum.
Mains Voltage set at factory 100, 120, 220, 230, 240 VAC, 50 Hz - 60 Hz.
Trigger In TRS connector for 5V external trigger.
Input Trim 0db, -6db, -12db,-18db of attenuation.
Power consumption 60W standby, 2W idle.